Hardkap

Macpup, Pritlog, Pritdeals discussion forums

Register or log in (lost password?):

Username:
Password:

Remember me

Hardkap » Macpup - The beauty of Linux

1. 

   LaneLester
   Member

   I don't know if I'll be able to give MacPup a test or not. I have an nVidia motherboard chipset that messes up the video until I get the right driver installed. This means that almost all distro LiveCDs look bad (Sabayon was the exception). However, with the exception of MacPup, LiveCDs have enough showing so that I can install them to the hard drive and get the video fixed. Whatever is at the bottom of the MacPup screen doesn't show, and there's not much in the right-click menu other than the terminal. Maybe I could execute the Puppy Universal Installer from the command line if I knew what the command is.

   Lane

   Posted 2 months ago #
2. 

   runtt21
   Member

   left click on the desktop should open the main menus , try running with xvesa the next time you run and see what happens.

   Posted 2 months ago #
3. 

   LaneLester
   Member

   Left click? (hitting forehead with hand) Yes, that got it done.

   And yes, xvesa gave me a desktop I could use, although it's not centered quite correctly.

   After I finished the frugal install and rebooted, I selected xorg, and then I installed the 190 nVidia driver .pet. Unfortunately, it didn't work and X was broken until I went back to xvesa. No time now, but I'm going to try copying the /etc/X11/xorg.conf from the successful Puppy 4.3.1 installation.

   Thanks for the good suggestions. I'm looking forward to exploring this Puppy.

   Lane

   Posted 2 months ago #
4. 

   runtt21
   Member

   I think you may need to use 4.3.0 if that dosen't work.

   Posted 2 months ago #
5. 

   LaneLester
   Member

   I'm delighted to say that it worked, and I have good xorg video now. I used the 185 driver instead of the 190, because that's the one I use in Ubuntu Karmic. After installing it, which broke X as before, I deleted xorg.conf and copied over the one from my standard Puppy 4.3.1 install.

   I should have retained the Macpup-installed xorg.conf for comparison, but I didn't.

   Lane

   Posted 2 months ago #

Important: If you want to be notified for any new post on this thread/topic, please go to your profile, activate favorite notification and then subscribe to this topic.

RSS feed for this topic

Reply

You must log in to post.